![]() ![]() Repeat the same process for the channel carrying Y Axis motor with pulley. From the center of the aluminum channel carrying pulleys, mark 8cm to both left and right. ![]() Insert two LM6UU linear bearing in a 6mm smooth rod.Fix the ends of the belt using a small nut, bolt and washer setup. Link the two pulleys using GT2 Belt such that the belt is not too tight or too loose.While fixing, the frame should be in such a way that the channels with two Z Axis motor must be opposite to each other or the channel with Y axis motor with pulley must be opposite to channel with the free running pulley. Make the base square frame using the aluminum channel by fixing the four channel using Angle bracket.Take a small screw or bolt through the pulley and fix it in the middle of another aluminum channel, such that the pulley and the Y Axis motor pulley is on the same line.Fix the Y Axis motor in the aluminum channel, such that the shaft carrying the GT2 pulley is on the middle of the aluminum channel.Untight the allen screw, and fix the GT2 Pulley in the X & Y stepper motor firmly by tightening the screw.Fix two Z Axis motors in the middle of the aluminum channel using Cable ties firmly.Untight the allen key screw of the 5mm to 8mm coupler and fix the coupler in the 5mm shaft of the Z Axis stepper motors.While working as Sticker Cutting machine, a pen knife or blade is made to fix in the Z axis instead of a pen, The given image is made to a sticker by the movement of the X, Y & Z axis.After, the text given as input is traced in a paper on a plane by the movement of X. While working as a homework writing machine, A software is used for obtaining the different hand written fonts.The sketch given as a input is traced in a paper on a plane by the movement of X, Y & Z axis. While working as a CNC sketcher, a pen is made to install in the Z axis while making the Hotend to OFF state.While working as a 3D printer, a filament material is melted using a heating element (Hotend) and is deposited on a plane according to the movement of the X, Y & Z axis.Here we are customizing a 3D printer, a homework writing machine, a CNC sketcher (Plotter) and sticker cutter to this CNC setup. Actually, we are making a basic CNC setup which we can customize according to our need. A CNC system works with the movement of X, Y & Z axis. The whole multitasking project works behind the principle of CNC operation. ![]()
0 Comments
Leave a Reply. |